Looking for pedestrian wind comfort simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 1

Simulacao de teste para projeto de iniciacao científica Insper 2020.

The purpose of this test case is to validate the mean surface pressure on a building with balconies, using the Lattice Boltzmann model for three wind directions.

wind comfort study for London area of walkie talkie building

The objective of this simulation is to demonstrate how to prepare a geometry with extreme terrain (mountainous area) and then simulate it in the PWC analysis type.

This project aims at assessing the pedestrian safety, comfort, and environmental impact of residential zones located in the district of Stockholm Royal Seaport.

For pedestrian comfort validation
Simulation of wind on a single building with a pedestrian tunnel

Pedestrian Wind Comfort Analysis for assessing the wind speeds in areas meant for recreational use.

Test setup to simulate the distribution of air pollutants with the wind flow.

The purpose of this project is to use experimental results from the Architectural Institute of Japan to validate CFD results gained from SimScale. The case being validated is Case E, which consists a complex of buildings with simplified geometry. Many scenarios are presented in Case E, The scenarios used to validate the SimScale platform were the North, East, South and Westerly winds for the after construction scenario.

The SimScale CFD results were compared to the experimental results and found to have good correlation. Some underprediction was seen in the k-epsilon models in the strong wind regions and underprediction in the wake regions, but is a known trait of the K-epsilon model and is acceptable and should be considered when evaluating results.

The purpose of this project is to use experimental results from the Architectural Institute of Japan to validate CFD results gained from SimScale. The case being validated is Case D, which consists of a single high-rise building, surrounded by blocks of simplified buildings. The geometry used was the scaled geometry from the data file provided by the Architectural Institute of Japan, and measurements were taken at points also listed in the data file.

pedestrian wind comfort | SimScale Project Library | Page 1